horstfuchs píše: ↑02 úno 2020, 22:54
Ramonka píše: ↑02 úno 2020, 21:49
1. Proč je linux tak náročný na RAM, když nedělám nic moc extra???
Ve Win 7 jsem měla puštěno i více programů a bez problémů. Teda občas jsem musela něco ukončit, ale ne vytažením PC ze zásuvky.
2. A ano, byl tam asi špatný nějaký... drive nebo co, který jsem pak instalovala.
To mě taky štve, že systém po mně pořád chce něco aktualizovat, a když to neudělám, padá. Když to udělám, tak za chvíli budu mít paměť totálně zasekanou...
3. Ne, ještě jsem Sophos neinstalovala. Akorát jsem zapnula Firewall. Obávám se, že pak už si video při práci sotva pustím. A vůbec, váhám, jestli spíš nezvolit to rozšíření SE Linux, jak tu někdo psal, ale ani k tomu jsem se ještě nedokopala.
1. Holka to neni linuxem, to je konkretni distribuci a prohlizecem.
ja mam 2GB ram, 12 oken +2 inkognito (3 gmaili) a v jednom mi jede youtube, nebo mi jede spotify.
jo jenomze nemam linux mint,
redhawk delal testy, mint a ubuntu skoncilo hodne zle....
2*
Linux Mint 19.2 xfce (odpočítané za využívanie prostriedkov, testy a wifi)
Ubuntu Mate 18.04.3 (odpočítané za využívanie prostriedkov a testy)
2. jak mas nastavenej swappines?
status v terminalu
kdyz mas ssd tak swappiness na 1, kdyz mas 4GB ram a hdd tak 10
zmenu provedes
najdi
vm.swappiness = a tu prepis
3. daj na radu, nedelej to. firwall jo, no nezahravej si s selinuxem nebo s av.... aneb hrej si, ale mej zalohu
Swappines - vyhodilo mi to č. 60.
Po zadání dalšího příkazu se mi otevřelo zvláštní okno, kde jsem ale
vm.swappiness nenašla:
#
# /etc/sysctl.conf - Configuration file for setting system variables
# See /etc/sysctl.d/ for additional system variables.
# See sysctl.conf (5) for information.
#
#kernel.domainname = example.com
# Uncomment the following to stop low-level messages on console
#kernel.printk = 3 4 1 3
##############################################################3
# Functions previously found in netbase
#
# Uncomment the next two lines to enable Spoof protection (reverse-path filter)
# Turn on Source Address Verification in all interfaces to
# prevent some spoofing attacks
#net.ipv4.conf.default.rp_filter=1
#net.ipv4.conf.all.rp_filter=1
# Uncomment the next line to enable TCP/IP SYN cookies
# See
http://lwn.net/Articles/277146/
# Note: This may impact IPv6 TCP sessions too
#net.ipv4.tcp_syncookies=1
# Uncomment the next line to enable packet forwarding for IPv4
#net.ipv4.ip_forward=1
# Uncomment the next line to enable packet forwarding for IPv6
# Enabling this option disables Stateless Address Autoconfiguration
# based on Router Advertisements for this host
#net.ipv6.conf.all.forwarding=1
###################################################################
# Additional settings - these settings can improve the network
# security of the host and prevent against some network attacks
# including spoofing attacks and man in the middle attacks through
# redirection. Some network environments, however, require that these
# settings are disabled so review and enable them as needed.
#
# Do not accept ICMP redirects (prevent MITM attacks)
#net.ipv4.conf.all.accept_redirects = 0
#net.ipv6.conf.all.accept_redirects = 0
# _or_
# Accept ICMP redirects only for gateways listed in our default
# gateway list (enabled by default)
# net.ipv4.conf.all.secure_redirects = 1
#
# Do not send ICMP redirects (we are not a router)
#net.ipv4.conf.all.send_redirects = 0
#
# Do not accept IP source route packets (we are not a router)
#net.ipv4.conf.all.accept_source_route = 0
#net.ipv6.conf.all.accept_source_route = 0
#
# Log Martian Packets
#net.ipv4.conf.all.log_martians = 1
#
###################################################################
# Magic system request Key
# 0=disable, 1=enable all
# Debian kernels have this set to 0 (disable the key)
# See
https://www.kernel.org/doc/Documentation/sysrq.txt
# for what other values do
#kernel.sysrq=1
###################################################################
# Protected links
#
# Protects against creating or following links under certain conditions
# Debian kernels have both set to 1 (restricted)
# See
https://www.kernel.org/doc/Documentation/sysctl/fs.txt
#fs.protected_hardlinks=0
#fs.protected_symlinks=0